Publication Type:Journal Article
Source:Economic GeologyEconomic Geology, Society of Economic Geologists, Inc, Volume 107, Number 8, p.1669-1694 (2012)
Keywords:Aluminum, Clay minerals, Debris, Hydrothermal synthesis, Shellfish, sulfur, Volcanoes
The Monowai volcanic center is located at the midpoint along the 2,530-km-long Tonga-Kermadec arc system. The Monowai volcanic center is comprised of a large elongate caldera (Monowai caldera area 35 km2; depth to caldera floor 1,590 m), which has formed within an older caldera some 84 km2 in area. To the south of this nested caldera system is a large composite volcano, Monowai cone, which rises to within 100 m of the sea surface and which has been volcanically active for the past several decades. Mafic volcanic rocks dominate the Monowai volcanic center; basalts are the most common rock type recovered from the cone, whereas basaltic andesites are common within the caldera. Hydrothermal plume mapping has shown at least three major hydrothermal systems associated with the caldera and cone: (1) the summit of the cone, (2) low-temperature venting (60C; Mussel Ridge) on the southwestern wall of the caldera, and (3) a deeper caldera source with higher temperature venting that has yet to be observed. The cone summit plume shows large anomalies in pH (a shift of -2.00 pH units) and 3He (&le358%), and noticeable H2S (up to 32 m), and CH4 (up to 900 nm). The summit plume is also metal rich, with elevated total dissolvable Fe (TDFe up to 4,200 nm), TDMn (up to 412 nm), and TDFe/TDMn (up to 20.4). Particulate samples have elevated Fe, Si, Al, and Ti consistent with addition to the hydrothermal fluid from acidic water-rock reaction. Plumes extending from 1,000- to 1,400-m depth provide evidence for a major hydrothermal vent system in the caldera. The caldera plume has lower values for TDFe and TDMn, although some samples show higher TDMn concentrations than the cone summit plume; caldera plume samples are also relatively gas poor (i.e., no H2S detected, pH shift of -0.06 pH units, CH4 concentrations up to 26 nm). The composition of the hydrothermal plumes in the caldera have higher metal contents than the sampled vent fluids along Mussel Ridge, requiring that the source of the caldera plumes is at greater depth and likely of higher temperature. Minor plumes detected as light scattering anomalies but with no 3He anomalies down the northern flank of the Monowai caldera most likely represent remobilization of volcanic debris from the volcano flanks. We believe the Monowai volcanic center is host to a robust magmatic-hydrothermal system, with significant differences in the style and composition of venting at the cone and caldera sites. At the cone, the large shifts in pH, very high 3He% values, elevated TDFe and TDFe/TDMn, and the H2S- and CH4-rich nature of the plume fluids, together with elevated Ti, P, V, S, and Al in hydrothermal particulates, indicates significant magmatic volatile metal contributions in the hydrothermal system coupled with aggressive acidic water-rock interaction. By contrast, the caldera has low TDFe/TDMn in hydrothermal plumes; however, elevated Al and Ti contents in caldera particulate samples, combined with the presence of alunite, pyrophyllite, sulfide minerals, and native sulfur in samples from Mussel Ridge suggest past, and perhaps recent, acid volatile-rich venting and active Fe sulfide formation in the subsurface. 2012 Society of Economic Geologists, Inc.
Compilation and indexing terms, Copyright 2018 Elsevier Inc.<br/>20124915756420<br/>Basaltic andesite<br/>Composite volcanoes<br/>Hydrothermal fluids<br/>Hydrothermal plume<br/>Hydrothermal system<br/>Hydrothermal vent<br/>Large shifts<br/>Low temperatures<br/>Magmatic volatiles<br/>Magmatic-hydrothermal systems<br/>Metal content<br/>Remobilization<br/>Rock types<br/>Scattering anomalies<br/>Sea surfaces<br/>Sulfide formation<br/>Ti content<br/>Tonga-Kermadec arc<br/>Volcanic centers<br/>Volcanic debris<br/>Volcano flanks<br/>Water rock interactions<br/>Water-rock reactions